Endress+Hauser TopClean S CPC 30, Руководство по эксплуатации

Страница: 27 / 146

TopClean S CPC 30 5 Operation
Hauser 27
5.1.4 Data logger
In the CPM 153, you have two data loggers available. With these data loggers you can
•
record a parameter with 500 sequential measuring points or
•
two parameters each with 250 sequential measuring points.
To be able to use the function, activate the data logger(s) in the "PARAM" menu
➞
"Set up 2"
➞
"Data logger" (s. page 48). The function is active immediately.
You can view the measured values by scrolling through the different measuring menus
(see above).
– The current measured values are recorded in Record mode.
– In the "PARAM" menu
➞
"Set up 2"
➞
"Data logger" you can open saved data by
stating the date and time.
5.1.5 Operation access authorisation
To protect the transmitter against an unintended or undesired change in the
configuration and calibration data, functions can be protected using four-digit access
codes.
Access authorisation has the following levels:
Display level (accessible without a code):
The complete menu can be viewed. The configuration cannot be altered. No calibration
is possible. On this level, only the control parameters for new processes can be
changed in the "DIAG" menu branch.
Maintenance code Maintenance level (can be protected by the maintenance code):
This code permits calibration.
Use this code to operate the temperature compensation item. The test functions and the
internal data can be viewed.
Factory setting Code = 0000, i.e. the levels are not protected.
In case you have mislaid/forgotten the supplied maintenance code, contact your
service office for a universally valid maintenance code.
Specialist code Specialist level (can be protected by the specialist code):
All menus can be accessed and changed.
Factory setting Code = 0000, i.e. the levels are not protected.
In case you have mislaid/forgotten the supplied specialist code, contact your service
office for a universally valid specialist code.
To activate the codes (= functions locked) see the item "PARAM"
➞
"Set up 1"
➞
"Access codes" (s. page 27). Enter your desired codes here. If the code is activated,
you can only edit the protected areas with the rights mentioned above.
Record mode Scroll mode
2.00 pH1 12.00
C07-CPM153xx-19-06-00-en-016
Measure
Select
2.00 pH1
7.54 12 15 35
01 04 2001
12.00
C07-CPM153xx-19-06-00-en-017
Measure
Select