Endress+Hauser TopClean S CPC 30, Руководство по эксплуатации

Страница: 65 / 146

TopClean S CPC 30 6 Commissioning
Hauser 65
Emebedded programme flow
Operating sequence: When first configuring, the following settings must be made:
1. Automatic operating mode :
– Here you enter the programme sequence.
– If you are only using the set programmes 1 to 3, you can enter all the settings here
(e.g. conveyance times, repeat cycles).
– You create the user-defined programmes 4 to 6 in the item "User programmes". After
editing, configuration and release, these are available to be used and can be
integrated into the weekly programme.
2. Cleaning cycle / Measuring cycle:
The cleaning cycle "Clean Int" is integrated into the weekly programme and is
configured there (see example below).
It cannot be started externally.
3. External start signals:
– You can start each programme directly via a 3 bit signal.
– To control the programmes using an external start signal, enter the settings of the
set programs (e.g. conveyance times, repeat cycles)
in the
"Automatic"
operating
mode
also.
– You create the user-defined programmes 4 to 6 in the item "User programmes". After
editing, configuration and release, these are available to be used.
Automatic
Each day of a week can be programmed individually.
"Clean Int": Cleaning is carried out at set intervals.
("Cleaning cycle": (Measuring time >> cl dwell time;
"Measuring cycle": Measuring time << cl dwell time)
"User": User-defined cleaning programmes (create in Programme Editor).
Clean Clean S User 1 - User 3
01 Assembly
Service
01 Assembly
Service
01
02 Water 30 s 02 Hot air 1200 s 02
03 Cleaner 15x 03 Wait 600 s 03
04 Wait 30 s 04 Rep. Steril. 0x 04
05 Water 30 s 05 Assembly Meas. 05
06 Rep. Cleaning 0x 06 ---------------------- 06
07 Assembly Meas. 07 Prog. time:_____ 07
08 ---------------------- 08 08
09 Prog. time:_____ 09 09
10 10 10
11 11 11
12 12 12
13 13 13
14 14 14
15 15 15
16 16 16
17 17 17
18 18 18 (up to 28
programme steps
possible)
19 19 19