Endress+Hauser TopClean S CPC 30, Руководство по эксплуатации

Страница: 130 / 146

11 Appendix TopClean S CPC 30
130 EHauser
PARAM
PARAM
Select
TopClean
Chemoclean
(only with
activated system)
(Data logger, Check,
Controller config. and
limit functions see
above)
C07-CPC30xxx-19-06-08-en-014.EPS
PARAM
Set up 1
Controller values
Manual operation
Quick Setup
Set up 2
PARAM
Set up 1
Set up 2
Manual operation
Quick Setup
Controller values
»Return field«:
press the PARAM
key to return to
the highlighted
fields.
= Code entry required
Limit switches 1..5
Function off
On-value 16.00pH
Off-value 16.00 pH
For selected day
Select programme:
Select with -> and +-
Activate by pressing
»E«
Edit using Start-/
End time arrows
Select
target day when
programme
should copy.
(From day list)
Display
programme as list
of function blocks
Highlight with
cursor and edit:
Back to
return field
Select TopClean
Configuration
Activate
TopClean
Status info field
of plant:
Automatic off
Cleaning trigger off
Ext. control off
Status info field
of plant:
Automatic off
Cleaning trigger off
Ext. control off
Status info field
of plant:
Automatic off
Cleaning trigger off
Ext. control off
List of weekdays
List of weekdays
with number of
programmes:
Select a day
Select
control levels:
Automatic off
Cleaning trigger off
Ext. control off
Power fai l off
Select
control levels:
Automatic off
Cleaning trigger off
Ext. control off
Power fail off Select operation
Spray levels
Automatic
User programme
Assign
additional valve
Valve =Steril/Steril/
User/---
if CPC-Fkt. is active,
this field is read-only)
Select TopClean
operation
Automatic
Cleaning trigger
Power failure
User prog.
Automatic:
List of weekdays
with number of
programmes:
Select a day
Select programme
for the
SCS cleaning off
programme list
Select programme
for power fail
programme from
programme list Note:
Power fail prog. is
only possible in
automatic mode!
Select for
selected day
Edit day?
Copy day?
Back to
return field
Select for
selected day
Edit day?
Copy day?
Enter name of
additonal valve
Text Editor
see user programme 1 on next page
Select:
Move assembly:
with sealing water
without sealing
water
Display
programme as list
of function blocks
Highlight with
cursor and edit:
Display
programme as list
of function blocks
Highlight with
cursor and edit:
For selected day
Select programme:
Select with -> and +-
Activate by pressing »E«
Edit using Start-/
End time arrows
Select
target day where
programme
should be copied.
(From day list)