Endress+Hauser Topcal S CPC310, Руководство по эксплуатации

Страница: 145 / 176

Troubleshooting
145
Behavior with NAMUR setting (contacts configured as normally closed contacts)
10.5.3 Response of contacts to power failure
The contacts can be defined as normally open or normally closed contacts in the "Set up 1 > Relays"
menu (see "Set up 1 - Relays" section). In the case of a power failure, the contacts will act according
to the setting you make.
10.5.4 Assembly behavior
10.6 Spare parts
Please order spare parts from your local sales center. For this purpose, use the order numbers listed
in the "Spare part kits" section.
You should always quote the following information on the spare parts order:
• Device order code
• Serial no.
• Software version if possible
You can refer to the nameplate for the order code and serial number.
The software version is provided in the device software (see "Operation" section) provided the
processor system of the device is still working.
Device status Alarm relay Maintenance
relay Function check Limit value / Controller
Normal operation Picked up (failsafe
behavior) Picked up Picked up Appropriate configuration
and operating status
Failure Dropped out Picked up Picked up Appropriate configuration
and operating status
Maintenance required Picked up Dropped out Picked up Appropriate configuration
and operating status
Function check Picked up Picked up Dropped out Appropriate configuration
and operating status
Voltage-free Dropped out Dropped out Dropped out Dropped out
Problem CPM153 behavior CPG behavior Assembly behavior
CPM153 voltage failure during
measurement No function
CPM153 voltage failure during
maintenance No function
CPG voltage failure during
measurement Error message E012 All valves closed Can be pressed from the process
CPG voltage failure during
maintenance Error message E012 All valves closed Stays in service position
Air failure during measurement Error message E027 Can be pressed from the process
Air failure during maintenance Error message E027 Stays in service position
Air failure during automatic
cleaning Error message E027 Stays in service position
Buffer 1 / 2 empty Error message E051/E052
Cleaner empty Error message E050