Endress+Hauser Proline Cubemass C 300, Руководство по эксплуатации

Страница: 98 / 216

Commissioning Proline Cubemass C 300
98 Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Switch-on value • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Enter measured value for the
switch-on point. Signed floating-point
number Country-specific:
• 0 kg/h
• 0 lb/min
Switch-off value • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Enter measured value for the
switch-off point. Signed floating-point
number Country-specific:
• 0 kg/h
• 0 lb/min
Switch-on delay • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Define delay for the switch-on
of status output. 0.0 to 100.0 s 0.0 s
Switch-off delay • The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
Define delay for the switch-off
of status output. 0.0 to 100.0 s 0.0 s
Failure mode – Define output behavior in
alarm condition. • Actual status
• Open
• Closed Open
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings
10.4.9 Configuring the relay output
The Relay output wizard guides the user systematically through all the parameters that
have to be set for configuring the relay output.
Navigation
"Setup" menu → Relay output 1 to n
‣
Relay output 1 to n
Terminal number →  99
Relay output function →  99
Assign flow direction check →  99
Assign limit →  100
Assign diagnostic behavior →  100
Assign status →  100