Endress+Hauser Proline Cubemass C 300, Руководство по эксплуатации

Страница: 162 / 216

Diagnostics and troubleshooting Proline Cubemass C 300
162 Hauser
Diagnostic
number
Short text Remedy instructions Status
signal
[from the
factory]
Diagnostic
behavior
[from the
factory]
599 Custody transfer
logbook full 1. Deactivate custody transfer mode
2. Clear custody transfer logbook (all
30 entries)
3. Activate custody transfer mode
F Warning
1)
Diagnostic of process
803 Loop current 1 faulty 1. Check wiring
2. Change I/O module F Alarm
830 Ambient temperature
too high Reduce ambient temp. around the
sensor housing S Warning
1)
831 Ambient temperature
too low Increase ambient temp. around the
sensor housing S Warning
1)
832 Electronics temperature
too high Reduce ambient temperature S Warning
1)
833 Electronics temperature
too low Increase ambient temperature S Warning
1)
834 Process temperature too
high Reduce process temperature S Warning
1)
835 Process temperature too
low Increase process temperature S Warning
1)
842 Process value below
limit 1. Decrease process value
2. Check application
3. Check sensor S Warning
1)
862 Partly filled pipe 1. Check for gas in process
2. Adjust detection limits S Warning
1)
882 Input signal faulty 1. Check input signal parameterization
2. Check external device
3. Check process conditions F Alarm
910 Tubes not oscillating 1. If available: Check connection cable
between sensor and transmitter
2. Check or replace sensor electronic
module (ISEM)
3. Check sensor
F Alarm
912 Medium
inhomogeneous 1. Check process cond.
2. Increase system pressure S Warning
1)
913 Medium unsuitable 1. Check process conditions
2. Check electronic modules or sensor S Warning
1)
915 Viscosity ouf of
specification 1. Avoid 2-phase flow
2. Increase system pressure
3. Verify viscosity and density are
within range
4. Check process conditions
S Warning
1)
941 API/ASTM temperature
out of specificat. 1. Check process temperature with
selected API/ASTM commodity
group
2. Check API/ASTM-related parameters
S Warning
1)
942 API/ASTM density out
of specification 1. Check process density with selected
API/ASTM commodity group
2. Check API/ASTM-related parameters
S Warning
1)
943 API pressure out of
specification 1. Check process pressure with selected
API commodity group
2. Check API related parameters
S Warning
1)
944 Monitoring failed Check process conditions for Heartbeat
Monitoring S Warning
1)