Endress+Hauser Proline Cubemass C 300, Руководство по эксплуатации

Страница: 100 / 216

Commissioning Proline Cubemass C 300
100 Hauser
Parameter Prerequisite Description User interface /
Selection / User
entry
Factory setting
Assign limit The Limit option is selected in
the Relay output function
parameter.
Select process variable for limit
function. • Mass flow
• Volume flow
• Corrected volume
flow
*
• Target mass flow
*
• Carrier mass flow
*
• Target volume
flow
*
• Carrier volume
flow
*
• Target corrected
volume flow
*
• Carrier corrected
volume flow
*
• Density
• Reference density
*
• Concentration
*
• Temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Oscillation
damping
• Pressure
• Application
specific output 0
*
• Application
specific output 1
*
• Inhomogeneous
medium index
• Suspended bubbles
index
*
Mass flow
Assign diagnostic behavior In the Relay output function
parameter, the Diagnostic
behavior option is selected.
Select diagnostic behavior for
switch output. • Alarm
• Alarm or warning
• Warning Alarm
Assign status In the Relay output function
parameter, the Digital Output
option is selected.
Select device status for switch
output. • Partially filled pipe
detection
• Low flow cut off
Partially filled pipe
detection
Switch-off value In the Relay output function
parameter, the Limit option is
selected.
Enter measured value for the
switch-off point. Signed floating-point
number Country-specific:
• 0 kg/h
• 0 lb/min
Switch-off delay In the Relay output function
parameter, the Limit option is
selected.
Define delay for the switch-off
of status output. 0.0 to 100.0 s 0.0 s
Switch-on value The Limit option is selected in
the Relay output function
parameter.
Enter measured value for the
switch-on point. Signed floating-point
number Country-specific:
• 0 kg/h
• 0 lb/min
Switch-on delay In the Relay output function
parameter, the Limit option is
selected.
Define delay for the switch-on
of status output. 0.0 to 100.0 s 0.0 s
Failure mode – Define output behavior in
alarm condition. • Actual status
• Open
• Closed Open
* Visibility depends on order options or device settings
10.4.10 Configuring the double pulse output
The Double pulse output submenu guides the user systematically through all the
parameters that have to be set for configuring the double pulse output.