Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 75 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 61
5 Operation and Maintenance
The pump is operated with the Chromeleon Chromatography Management System. For
details, see section 5.3 (

page 64).
In addition, function keys and menus are available on the pump display to facilitate operation
during, for example, initial installation of the pump or maintenance procedures. They allow
you to perform certain actions directly from the pump, such as:

Executing certain commands (purge, set flow)

Setting parameters (leak sensor mode, brightness and contrast of the screen display)

Viewing and changing the pump configuration
For details, see section 5.4 (

page 70).
5.1 Power-Up
To start the pump for the first time, turn on the main power switch on the rear panel of the
pump. The following sequence of events occurs when the pump is powered up:

For a short time, general information about the pump appears on the pump display: device
type, serial number, and bootloader and firmware versions.

The pump runs a series of internal tests. During these self-diagnostics, all of the main
components are checked. When the self test was successful, the initial screen changes to
the status screen (

page 62).

If an error is detected, the pump is not ready for analysis. The Status LED on the front
panel door changes to red and a message appears on the pump display. If the pump is
operated with Chromeleon, the message is also displayed in the Chromeleon Audit Trail.
Turn off the pump, take appropriate remedial action (

page 103), and turn on the pump
again.
For routine operation, leave the main power switch on. For routine on/off control, use the
standby button on the front of the pump (

page 12). Press and hold the button for one
second to allow the pump to change the mode. Turn the main power switch off when
instructed to do so, for example, before performing a service procedure.