Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 94 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Page 80 Operating Instructions
5.5.2 Linking the Pump to the Autosampler
Only if the UltiMate 3000 system includes a WPS-3000 or ACC-3000
In this case, you can specify which pump is linked to the autosampler. Dionex recommends
always specifying a pump because this setting

Indicates which pump delivers the flow. The information is important if you want to
operate the system in bypass mode (possible only with WPS-3000SL and WPS-3000RS).
For information about the bypass mode, see the Autosampler Manual or Chromeleon
Help.

Allows synchronizing the injection command of the autosampler with the strokes of a
low-pressure gradient pump (DGP-3600 or LPG-3400). Synchronization ensures that all
injections are performed at the same phase of the pump cycle, considerably enhancing the
retention time precision with gradient applications.
1. Start the Server Configuration program (

page 34).
2. Right-click the autosampler in the timebase and click Properties on the menu.
3. Click the Segments / Pump Link page and select the pump to which the autosampler is
linked. Select the pump to which the autosampler is linked on the Flow through
sampler is delivered by pump(s) list.

If the UltiMate 3000 system includes a DGP-3600 pump
Select UM3PUMP_L_STRK to link the autosampler to the left pump. To link the
autosampler to the right pump, select UM3PUMP_R_STRK .

If the UltiMate 3000 system includes a pump other than a DGP-3600
Select UM3PUMP_STROKE .

If you do not want to link the autosampler to a pump
Select <None> .
The pump link setting on the Segments / Pump Link page is the default setting. To
change the setting for a specific application, use the SyncWithPump and PumpDevice
properties in the Commands dialog box or in the program (PGM).

To disable synchronization, set SyncWithPump to Off .

To use a different pump, enter the pump under PumpDevice , and then verify that
SyncWithPump is set to On .
The default setting on the Segments / Pump Link page remains unchanged.