Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 109 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 95
Liquid Level
Waste Container Description
WasteLevel Set the following:
Value The liquid level in the waste container at the beginning of a sequence.
UpperLimit
The upper limit for the liquid level.
If the liquid level in the waste container reaches the upper limit and
- an emergency program is available in Chromeleon, the pump is stopped as
defined in the program.
-
no emergency program is available in Chromeleon, the batch is aborted,
the pump flow is stopped, and the related message appears.
WasteWarningLimit Set the limit when you want to be informed about the liquid level in the waste
container. The input is in percent and refers to the upper limit.
The message appears when the liquid level is above the upper limit x warning
limit\100 (= WasteLevel.UpperLimit x WasteWarningLimit/100).
WasteRemain Time Reports the time left until the liquid level is expected to reach the upper limit.
The time is calculated from the current flow rate and the calculated current
liquid level.
For more information about the properties in the table and about emergency programs, see
the Chromeleon Help.
Only DGP-3600
In the Properties dialog of the pump, on the Bottles page, the default setting is that both pumps
of the DGP-3600 are connected to the same solvent reservoirs and waste container
(

page 40).
With this setting, Chromeleon assigns the two eluent properties, %A/B/C_RemainTime and
%A/B/C_WarningLimit , and the two waste properties, WasteRemainTime and Waste
WarningLimit , the same values for each pump.
Clear the check boxes on the Bottles page if the two pumps are connected to different solvent
reservoirs and/or waste containers. Chromeleon will then support the properties for both
pumps separately.