Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 17 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 3
At various points throughout the manual, messages of particular importance are indicated
by certain symbols:
Tip: Indicates general information, as well as information intended to
optimize the performance of the instrument.
Important: Indicates that failure to take note of the accompanying information
could cause wrong results or may result in damage to the module.
Important: Indique que ne pas tenir compte de l'information jointe peut conduire
à de faux résultat ou endommager l'instrument.
Warning: Indicates that failure to take note of the accompanying information
may result in personal injury.
Avertissement: Indique que ne pas tenir compte de l'information jointe peut
entraîner des blessures corporelles.
1.2.2 General Safety Precautions
When working with analytical instrumentation, you should know the potential hazards of
using chemical solvents. Wear appropriate protective clothing.
Tips : Before initial operation of the pump, make sure that you are familiar with the
contents of this manual.
Observe any warning labels on the pump and see the related sections in these
Operating Instructions .
To avoid the possibility of personal injury and damage to the instrument, observe the
following general safety precautions when operating the pump or carrying out any
maintenance work:

Install the HPLC system in a well-ventilated laboratory. If the mobile phase includes
volatile or flammable solvents, do not allow them to enter the workspace.

For minimum interference effects, all components of the analytical system should be
connected to the same mains output (same phase).

The pump is primed with 2-propanol. During initial operation of the pump, make sure that
the solvents used are miscible with 2-propanol. Otherwise, follow the appropriate
intermediate steps.

When lifting or moving the pump, always lift by the sides of the instrument. Lifting the
pump by the front panel may damage the front panel door.