Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 157 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 143
4. Push the piston seal tool into the pump head as far as it goes in.
5. Remove the tool from the pump head. The piston seal and the support ring remain in
the pump head.
Fig. 43: Seal installed in the pump head
6. Insert the rear seal wash body (pump head bushing). Mind the correct orientation
(

Fig. 44). The even side faces the pump head; the opposite side faces the plate of
the rear seal wash system.
Fig. 44: Orientation of the rear seal wash body
7. Place the plate of the rear seal wash system onto the pump head as shown in the
picture. (The channels in the plate are facing you.)
Fig. 45: Plate of the rear seal wash system installed
8. Install the pistons and pump head (

page 137).
9. After replacing the piston seals, observe the recommendations on page 144.
10. Update the related service information in Chromeleon for the pump head for which
you replaced the piston seals and/or support rings. To do so, perform the
SealChanged command for the piston seals and the SupportRingChanged command
for the support ring (

page 91).
This side faces
the pump head.
This side faces the plate of
the rear seal wash system.