Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 45 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 31
3.4.3 Connecting the Power Cord
Use the power cord shipped with the pump to connect the instrument to the main power
source. Connect the power cord from the main power receptacle on the rear panel
(

Fig. 2, page 17) to a grounded power source. No manual adjustment is required to
adapt the line voltage to local voltage requirements.
For minimum interference effects, all components of the UltiMate 3000 system and the
Chromeleon computer should be connected to the same mains output (same phase).
3.4.4 Connecting the Solvent Rack and Digital I/O
Solvent Rack
If the UltiMate 3000 system includes an SRD-3x00 Solvent Rack, connect the solvent rack
port on the rear panel of the pump to the related port on the rear panel of the Solvent Rack.
The appropriate connection cable is included in the accessories pack of the Solvent Rack.
Digital I/O
To connect devices to the digital I/O ports on the rear panel of the pump, use a 6-pin mini-DIN
signal cable. The cable is available from Dionex (part no. 6000.1004).
1. Plug the 6-pin connector of the mini-DIN cable into the Digital I/O port 1 (or 2 ). For
information about the functions of the connector pins and pin assignment, see
page 215.
2. For each relay output or digital input to be used, connect the appropriate signal wire
and ground wire to the corresponding connectors on the external device
(

documentation provided with the external device).
3. When setting up the pump in the Chromeleon Server Configuration program
(

page 35), select the corresponding relay outputs on the Relays page and the digital
inputs on the Inputs page.
Tip: If you want to connect an ESA Corona or Coulochem III detector to the pump,
refer to page 43 for details.