Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 32 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Page 18 Operating Instructions
2.5.1 Power Switch
The power switch on the rear panel is the main power switch for the pump. Turn on the
power switch before initial operation of the pump and leave it on. For routine operation,
leave the main power switch on. For routine on/off control, use the standby button on the
front of the pump (

page 16). Press and hold the button for one second to allow the pump
to change the mode. Turn off the main power switch when instructed to do so, for example,
before performing a service procedure or when interrupting operation for longer periods
(one week or more). In this case, also observe the precautions on page 97.
2.5.2 Fuse Cartridge
The fuse cartridge contains two slow-blow fuses rated at 2 A, 250 V. For information
about how to change the fuses, see page 158.
2.5.3 USB Connector
The Chromeleon Chromatography Management System can use a USB connection to
control the pump. Data is transferred digitally by the appropriate USB cable (

page 30).
To ensure trouble-free operation, use only the cables shipped with the pump.
You can use the internal USB hub (

Fig. 2, no. 10) to connect three other instruments in the
UltiMate 3000 product line, depending on the configuration of the UltiMate 3000 system, or
three external USB hubs to the pump.
Important: Use these USB ports only for connections to Dionex instruments.
Dionex cannot guarantee correct functioning if instruments from other
manufacturers are connected.
Important: Dionex recommande d'utiliser les ports USB uniquement pour les
raccordements aux instruments Dionex. Dionex ne peut garantir le bon
fonctionnement si les instruments d'autres fabricants sont raccordés.
For information about how to connect the pump to the Chromeleon computer, see
sections 3.4.1 and 3.4.2 (

page 30).