Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 141 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 127
7.3.3 Replacing the Detector
Description Part No.
Detector of the rear seal wash system
Note the information for NP applications (

page 84).
6040.4131
1. Remove the seal wash tubing from the detector (

Fig. 30).
2. Unplug the detector cable from the Drop Det connector on the interior front panel.
3. Remove the securing clip for the detector toward you, and then remove the detector
toward to top.
4. Install the new detector following the above steps in the reverse order.
Connect the tubing to the inner port (

Fig. 30). The outer port has no function.
7.3.4 Cleaning the Detector
The detector can be contaminated by deposits impairing the correct functioning of the seal
wash system.
1. Remove the detector as described in section 7.3.3.
2. Clean the detector with distilled water and wait until the detector is dry. The
electrodes in the detector cap are critical for proper operation. Therefore, be careful
not to bend or otherwise damage them during cleaning.
Fig. 32: Detector of the seal wash system
3. Reinstall the detector.
Electrodes