Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 67 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 53
4.5 Connecting Drain Tubing
To discharge liquids that might have accumulated in the interior and the seal washing
liquid, the pump has a drain port at the bottom right of the instrument.
Fig. 16: Drain port
Direct liquid leaks to waste through the drain system of the UltiMate 3000 system. The
required components are shipped with the pump, but can be ordered also separately. The
drain kit (part no. 6040.0005) includes all components for system drainage and detailed
installation instructions.
Verify that the seal washing liquid is discharged properly to the waste.
1. Remove the securing clip for the detector toward you, and then remove the detector
toward to top.
Fig. 17: Detector of the seal wash system
2. Fill the connection port of the seal wash system several times with HPLC-grade water
(

Fig. 18) until the liquid exits the drain port at the bottom right of the pump.
Fig. 18: Filling water into the connection port
3. Verify that the liquid is discharged properly. If it is not, any modules that are located
below the pump in the UltiMate 3000 system stack may suffer severe damage from the
liquid leaving the drain port.
Detector of the
seal wash system
Securing clip