Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 55 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 41

Share Waste Bottle
The check box is selected by default. Accept this setting if both pumps of the DPG-3600
are connected to the same waste container.
If the check box is selected, Chromeleon assigns the two waste properties,
Waste_RemainTime and Waste_WarningLimit , the same values for each pump. (The
waster properties are available, for example, in the Commands dialog box under
PumpModule > [Pump Device Name] (

page 37).)
Clear the check box if the pumps are connected to different waste containers. With this
setting, Chromeleon supports the two waste properties separately for each pump.
For more information about liquid level monitoring, see page 94.
Signals Page
The Signals page lists all available signals. Select a check box to enable the corresponding
signal. If a check box is cleared, the signal will not be available in Chromeleon. To change
a signal name or the scaling factor, overwrite the existing entry directly in the
corresponding line. To change the pressure unit, make your selection on the
Limits page.
The signal for the pump pressure ( Pump_Pressure) is selected by default (with a DGP-3600,
Pump_PressureLeft and Pump_PressureRight ). Accept this setting if you want to record
the pump pressure. Chromeleon then generates the appropriate channels for data acquisition.
For more information, see section 5.5.5 (

page 83).
Relays Page
The Relays page lists all available relays. Select a check box to enable the corresponding
relay. If a check box is cleared, the relay will not be available in Chromeleon. To change a
relay name, overwrite the existing name directly in the corresponding line. For more
information about the relays, see page 19.
Inputs Page
This page lists all available remote inputs. Select a check box to enable the corresponding
remote input. If a check box is cleared, the input will not be available in Chromeleon. To
change an input name, overwrite the existing name directly in the corresponding line.