Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 90 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Page 76 Operating Instructions
5.4.2.5 Diagnostics Menu
The Diagnostics menu provides information for diagnostic purposes (read-only). In addition,
you can perform a self test.
To … Select ...
Perform a self test.
If an error or mechanical fault is detected, the
Status LED on the front
panel door changes to red and a message appears on the pump display.
Self test
See the compression value of the last stroke for the related pump head. The
value is indicated in percent. For more information about the compression
value, see page 121. Compression right
Compression left
Compression
See the workload of the related pump block since the pump has been
operated for the first time. The workload is calculated from the flow rate,
pressure, and time. Workload right
Workload left
Workload
See the pump model. Model
See which firmware version is installed. Firmware version
See the bootloader version. Bootloader version
See the serial number of the pump. Serial number
5.4.2.6 Configuration Menu
The Configuration menu provides information about the pump configuration and allows you
to make the required settings and change the settings:
To … Select ...
Set the display and function key parameters:
Brightness —sets the screen brightness. (The input is in percent.)
Contrast —sets the screen contrast. (The input is in percent.)
Key sound —sets whether a beep sounds when you select a function key: On—
yes or Off—no.
Key autorepeat —sets whether the keystroke is automatically repeated when
you remain on the key for a longer period, for example, to change a value
quickly (
On = yes or Off = no).
Display & soft keys
turn leak detection off if necessary and on again:
Disabled —turns leak detection off.
Enabled —turns leak detection on.
Leak detection is enabled as a standard. For more information about how
operate the pump with leak detection, see page 86.
Leak sensor mode
Set the pressure unit. Pressure unit
Restore the Dionex standard settings.
In the
Reset to factory defaults? dialog box, select OK to confirm the restore
or select Cancel to keep your settings.
Reset to factory
defaults