Services
Location information
Digi Connect IT® 16/48 User Guide
385
d. Click
again to add an additional point, and continue adding points to create the
desired polygon.
For example, to configure a square polygon around the Digi headquarters, configure a
polygon with four points:
This defines a square-shaped polygon equivalent to the following:
7. Define actions to be taken when the device's location triggers a geofence event:
n
To define actions that will be taken when the device enters the geofence, or is inside
the geofence when it boots:
a. Click to expand
On entry
.
b. (Optional) Enable
Bootup action
to configure the device to perform the
On entry
actions if the device is inside the geofence when it boots.
c. For
Number of intervals
, type or select the number of
that must
take place prior to performing the
On entry
actions.
For example, if the
Update interval
is
1m
(one minute) and the
Number of
intervals
is
3
, the
On entry
actions will not be performed until the device has been
inside the geofence for three minutes.
Содержание Connect IT 16
Страница 1: ...Digi Connect IT 16 48 User Guide Firmware version 21 2 ...
Страница 157: ...Interfaces Bridging Digi Connect IT 16 48 User Guide 157 8 Click Apply to save the configuration and apply the change ...
Страница 440: ...Services Configure the ping responder service Digi Connect IT 16 48 User Guide 440 iperf Done ...
