ComAp InteliMains NT IM-NT, Справочное руководство

Страница: 157 / 437

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf,
©ComAp – April 2015
157
Description The setpoint is used for selection of the load control mode in parallel to mains
operation if the load is controlled by the InteliMains (i.e.
#SysLdCtrl PtM =
LDSHARING).
SYSBLD->LS The load of the gen-set group is maintained at
constant level adjusted by the setpoint
#SysBaseLoad .
ANEXSYSBLD->LS The load of the gen-set group is maintained at
constant level given by the analog input
MLC:AnExSysBld .
IMP/EXP The load of the gen-set group is controlled so,
that the mains import is maintained constant at
the level adjusted by setpoint
Import load .
ANEXT IMP/EXP The load of the gen-set group is controlled so,
that the mains import is maintained constant at
the level given by the analog input
MLC:AnExI/E .
T BY PWR The load of the gen-set group is controlled so,
that the analog input
MLC:TByPwr is maintained
at constant level given by setpoint TempByPwr
Treq . The regulation loop is adjusted by setpoints
TempByPwr gain and TempByPwr int .
N
OTE
:
If the system baseload value needs to be changed remotely via a
communication interface select the ANEXSYSBLD->LS mode and then
configure one of the objects
ExtValue1 .. ExtValue4 as the source for the
analog input MLC:AnExSysBld . These objects can be written remotely via
communication (e.g. via MODBUS).
C
AUTION
!
Do not use cyclic write of the baseload setpoint for remote load control. It
may cause the internal EEPROM memory damage.
11.2.1.8 Setpoint: Soft Unload
Group Process Control
Range [units] STANDARD, AuxCTGen, AuxCTLoad [-]
Related FW standard v3.1.0
Description This setpoint adjusts the way MGCB opening is evaluated in case of unloaded