CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 323 / 359

CCI.Command
– Troubleshooting
80
Error Possible cause Rectification/approach
In spite of calibration, the
position of the field boundary is
not correct.

Reference point is not
correctly approached.

Check the position of the
tractor, approach the
reference point again.

Position of the GPS aerial
on the tractor is changed
after setting.

Check the position of the
GPS aerial and, if
necessary, enter again (see
operating instructions
CCI.GPS ).

Poor GPS signal quality.

(see next point)
The implement switches on
and off too early/late.

Poor GPS signal quality

Check the signal quality,
drive out of any shadow
region (if necessary
recalibrate any reference
point).

Incorrect geometry settings

Refer to the implement
operating instructions to see
how these can be changed.

Incorrect setting of the
position of the
Connection
point /aerial

Re-measure and check the
settings in
CCI.GPS .

Check the selection of the
Connection point in
CCI.Command .

Incorrect delay times

If these are transferred from
the implement, consult the
implement operating
instructions

If these were set by you,
verify the
delay times . To do
this work a strip and mark
the outer worked edge e.g.
with barrier tape. Drive over
this strip at a 90° angle and
measure how many cm the
implement was switched off
too early/too late. Divide this
value (cm) by the average
speed in the headland area
(cm/ms) (e.g. 8 km/h
corresponds to 0.22
cm/ms). This correction
value must be added to the
set value if switching off is
too late and subtracted from
it if switching off is too early.