CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 277 / 359

CCI.Command
– Operation
34
Overlapping
The Overlap setting is used to compensate for steering faults and GPS
inaccuracies.
There are 2 possible applications:
1. Missed areas must be avoided.
In this case a positive value must be entered. This results in the distance
between the
lead tracks being reduced by the entered value. This reduces the
effective working width, missed areas are avoided and overlapping can occur.
2. Overlapping must be avoided.
In this case a negative value must be entered. This results in the distance
between the
lead tracks being increased by the entered value. In this way
overlapping is avoided and missed areas can occur.
.
4.3.4.2 Enter the overlap value
Proceed as follows to enter the Overlap value:
1. Press on the "Overlap" button on the touchscreen or turn the scroll wheel until
the button is highlighted in white and then press on the scroll wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2. Enter the value on the touchscreen using the number pad or the slider.
3. Confirm your entry with "OK".
Note
Values between -100 and +100 cm are valid for the overlap .