CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 317 / 359

CCI.Command
– Operation
74
4.4.6 Create field boundary
To create a field boundary, proceed as follows:
1. Drive around the field while treating the headland. The worked area is
highlighted in blue; with field sprays, at this point in time, the Section Control
auto-mode can be immediately activated.
1.
Caution!
Sections are only automatically switched on, if an already treated area is reached.
Switching off at the field edge to protect the adjoining areas is the responsibility of
the user.
Note
For safety reasons, when operating with fertilizers the sections must be manually
switched during the first circumferential run around the field without a field
boundary.
2. Press the "Create field boundary" button (F1) on the touchscreen .
→ The field boundary is created and saved on the outside edge of the
already worked area. Gaps are closed by a matched line. Nevertheless, it
is worthwhile travelling around the full periphery of the
field , as the
calculations do not necessarily correspond to the actual course of the field
boundary.
→ The button "Create field boundary" (F1) changes automatically to "Delete
field boundary" (F1). This is indicated by another symbol.
4.4.7 Delete field boundary
To delete a saved field boundary, proceed as follows:
1. Press the "Delete field boundary" button (F1) on the touchscreen .
2. Confirm the prompt for confirmation with "OK".
→ The button "Delete field boundary" (F1) changes automatically to "Save
field boundary" (F1). This is indicated by another symbol.