CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 305 / 359

CCI.Command
– Operation
62
Correcting direction of travel
(see chapter 4.4.9)
Change Section Control mode
(see chapter 4.4.10)
Enter the desired headland width
Change the position of the marker
Change headland mode
Delete headland
4.4.1.4 Mark curves
To mark curves when recording the headland, proceed as follows:
1. Press the "Mark curves" (F3) button on the touchscreen .
→ Recording of the headland along the precise driven route starts.
2. Drive along the route.
3. Press the "Mark curves" (F3) button on the touchscreen again.
→ Recording of the headland along the precise driven route starts.
→ The recorded headland is saved.
4.4.1.5 Mark line
To mark a line when recording the headland, proceed as follows:
1. Press the "Mark line" (F4) button on the touchscreen .
→ The start point is set.
2. Drive to the point that is to form the end of the line and on the touchscreen
press the button "Mark line" (F4) again.
→ A line between the start and stop point is automatically drawn and a
headland created along this.
→ The created headland is saved.