CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 318 / 359

CCI.Command
– Operation
75
4.4.8 Set A point / record reference track
To record a reference track for Parallel Tracking , proceed as follows:
1. in the touchscreen press on the button "Set A point" (F2) to specify the start
point for the reference track .
→ The button "Set A-point" (F2) changes to "Set B-point" (F2). This is
indicated by another symbol.
2. Travel over the distance, that is to serve as the reference track .
3. In the touchscreen press on the button "Set B-point" (F2) to specify the end
point for the reference track .
→
Parallel tracking is automatically started.
Note
One reference track is saved per field.
If you set a new A-point, the existing reference track is overwritten. Confirmation of
the prompt for confirmation is necessary to do this.
4.4.9 Correcting direction of travel
If reverse gear detection is activated, see also chapter 4.3.5.6, CCI.Command
automatically detects the direction of travel. To correct the detected direction of
travel, proceed as follows:
1. Press the "Correct direction of travel" button (F5) on the touchscreen .
→ The direction of travel changes from "Forward travel" to "Reversing" or
from "Reversing" to "Forward travel".
→ The correction is displayed through changing of the symbol on the button
(F5).
Note
If CCI.Command detects reversing, a small red arrow is displayed.