CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 250 / 359

CCI.Command
– Introduction
7
1.3.4 Operation with implement
1.3.4.1 Non-ISOBUS-compatible
When operating with a non- ISOBUS enabled implement, the following functions
are available to you:

Parallel Tracking after manual entry of the working width

Manual labelling of the worked area
1.3.4.2 ISOBUS enabled and task controller enabled
When operating with an ISOBUS and task controller enabled implement, the
following functions are available to you:

Parallel Tracking (working width is automatically transferred)

Automatic identification of the worked area (working state of the implement is
transferred if an active task exists).
An ISOBUS and task controller enabled implement corresponds to the AEF
functionalities TC-BAS and TC-GEO (see chapter 8).
1.3.4.3 ISOBUS enabled and Section Control enabled
When operating with an ISOBUS and Section Control enabled implement, the
following functions are available to you:
1. Parallel Tracking (working width is automatically transferred)
2. Automatic identification of the worked area (working state of the implement is
transferred if an active task exists).
3. Automatic Section Control (geometry is transferred from the implement).
An ISOBUS and Section Control enabled implement corresponds to the AEF
functionality TC-SC (see chapter 8).