CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 326 / 359

CCI.Command
– Troubleshooting
83
Button Possible cause Rectification
Switch the marking of the
worked area on or off The connected implement is
ISOBUS and Section Control
enabled.
Manual marking is not
necessary, because the
implement signals its
working state and this is
automatically recorded.
Switch into auto mode The connected implement is not
ISOBUS and Section Control
enabled or still no field boundary
has been created (when using a
fertilizer).
Add headland/ Delete headland
The value 0.00 m is entered for
the headland distance. Enter a value greater than
0.00 m for the headland
distance (see chapter
4.3.5.5)
Import field boundary/ Export
field
Flash drive is not plugged in or is
not yet detected. Plug in flash drive and
wait until the
terminal
detects it.
5.4 Error messages
Note
The error messages shown on the terminal depend on the connected implement.
A detailed description of the possible error messages and troubleshooting can be
referred to in the implement operating instructions.
Note
If the implement cannot be operated, check whether the "stop switch" is pressed in.
The implement cannot be operated until the button has been released.