Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS, Функциональное описание

Страница: 480 / 490

17-10
Index ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
SA1 not allowed 12-55
SAC 6-56
Safety Instructions for Electric Drives and Controls 3-1
Select controller type 10-40
Select motor type 10-40
Select Parameter Mode 12-59
Select the Download Baud Rate 4-19
Serial Communication 10-14
Serial I/O Error 12-60
Service Data Channel 11-9
SET 6-60, 7-1
Set absolute distance 9-48
Set absolute measuring 12-38
Set Absolute Position, Press Encoder 9-52
Set Drive Absolute Encoder 9-48
Set module address 15-20
SETC 7-1
SETCN 7-1
Setting absolute encoder not possible when RF set 12-38
Setting the acceleration feedforward 8-50
Setting the Current Controller 8-42
Setting the Measuring Wheel Encoder Parameters 8-3
Setting the Motor Type 5-2
Setting the Position Control Loop Monitor 8-49
Setting the Position Controller 8-47
Setting the Velocity Loop 8-42
Setup Mode 9-23
Signal amplitude wrong 12-9
Signal Assignment for X30 Profibus Connector 11-17
SIS 4-9
Smoothing time constant 8-43
Determining the smoothing time constant 8-43
Source Numbers for the Marker Flags 10-2
Source Numbers of the Outputs 10-2
Special Displays 14-16
SRM 6-61
SRP 6-63
SSI Format 8-58
SSI-Encoder Error (PLS) 12-61
ST 7-1
Stack correction value > 9 12-59
Stack overflow with JSR command 12-51
Stack overflow with RTS command 12-51
Start input 10-3
Start-Up 4-1
Status classes
Reset status class 1 4-5
STN 7-1
Stop input 10-4
Stop is active 12-65
Supported Measuring Systems 1-3
Supported Motor Types 1-3
Switch to Parameter Mode 12-39
Synchronous Motors 5-3
System control offline 12-63
System control via RS 9-40
System Inputs 10-3
System inputs set by the Logic Task 9-40
System Marker Flags Inputs 10-10
System Marker Flags Outputs 10-11
System Outputs 10-6
System Variable
V000 _Cycle Counter 1_ 6-7
V001 _Cycle Counter 2_ 6-7
V002 _Current Program Instruction in Task 1_ 6-7
V003 _Current Program Instruction in Task 2_ 6-7
V004 _Current Program Instruction in Task 3_ 6-7
V007 _Analog Input 1_ 6-7
V013 _Strokes per Minute_ 6-7
V014 _Feed Angle Load_ 6-8
V015 _Feed Length of the IDS1.1-1_ 6-8