Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS, Функциональное описание

Страница: 406 / 490

12-58
Diagnostic Message Descriptions ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
F- 0308 AT Failure
The initialization of communication between the drive and NC is not o.k.
Cause:
•
Data loss.
•
Firmware update was executed. Previously, a different firmware or a
different version was loaded.
Remedy:
If possible, pre-select Parameter Mode and clear the error message.
Using S1, S2, and S3 on the programming module, execute a ’Load
parameters with default values.’ (See Chapter 4 ’S1 Key on Programming
Module.’)
If the error continues to occur:
Please contact REXROTH Customer Service. Explain precisely under
what circumstances the error occurred. The firmware should be replaced.
F- 0309 NC cycle error
The initialization of communication between the drive and NC is not o.k.
Cause:
•
Data loss.
•
Firmware update was executed. Previously, a different firmware or a
different version was loaded.
Remedy:
If possible, pre-select Parameter Mode and clear the error message.
Using S1, S2, and S3 on the programming module, execute a ’Load
parameters with default values.’ (See Chapter 4 ’S1 Key on Programming
Module.’)
If the error continues to occur:
Please contact REXROTH Customer Service. Explain precisely under
what circumstances the error occurred. The firmware should be replaced.
F- 0310 Parameter error
1. A parameter contains invalid data.
2. The contents of a parameter element is too large or too small.
3. The contents of a combination of parameters is not permitted.
Incorrect parameter combinations:
•
A100: The motion type ’continuous’ or ’rotary table’ is
programmed and in Parameter CM00, a linear motor is
pre-selected.
•
A107: The ’setup velocity’ is greater than A106 ’Maximum
Velocity.’
•
A111: The ’switching threshold’ is greater than A105 ’Modulo
Value’ for A100 Motion Type ’Rotary Table.’
•
AA19: The ’timeout duration’ is set in the parameters, but the
press function is not activated in AA12.
•
B009: ’Serial inputs/outputs’ are set in the parameters, but no
SIS protocol is pre-selected in B002.