Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS, Функциональное описание

Страница: 479 / 490

ECODRIVE03-FL*-04VRS Index
17-9
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Position mode with encoder 1 12-45
Position mode with encoder 2 12-45
Position mode without lag, encoder 2 12-46
Position mode without position lag (following error), encoder 1 12-46
Position of the zero pulse relative to the motor position 8-55
Positive travel limit exceeded 12-17
Positive travel limit switch detected 12-18
Power Failure Bit 8-58
Power supply driver stages fault 12-21
Power supply to outputs
external 15-16
internal 15-16
Preparations for Programming the Velocity Loop 8-42
Preparations for Setting the Position Control Loop 8-47
Press Timeout 12-65
Probe 10-5
Process Data Channel 11-3
Processor watchdog timer 12-29
Profibus 11-2
User-Configurable I/O 11-6
Profibus Connector X30 11-17
Profibus DP address 11-2
Profibus Inputs 10-8
Profibus Outputs 10-8
Profibus-DP 1-3
Program run without power 12-53
Programming possible only in loader 4-14
Proportional gain
Determining the critical proportional gain 8-43
Protection
technical data 15-3
PSA 6-50
PSI 6-51
PTC 5-1
R
R 7-1
Rated current
Saving in the motor feedback memory 5-1
Read Control Word 11-6
Read error 4-14
Read Status Word 11-6
Ready for power on 12-45
Rejection filter 8-46
Removing the EMD Base Module 15-10
REP 6-52
Requirements for a Correct Setting for Acceleration Feed Forward 8-50
RES 7-1
RESC 7-1
RESCN 7-1
Reset class 1 diagnostic, error reset 12-39
Reset possible only in loader 4-14
Resolution with absolut encoder emulation 8-58
Restart not allowed in phase 3 4-14
Restart not allowed in phase 4 4-14
RF 10-5
Rotary table mode 6-52
RS232 Mode 10-14
RS485 Mode 10-14
RTM 6-52
RTM not allowed 12-54
RTS 6-53
S
S 7-1
S1 key 4-1
S2 / S3 buttons 10-15
SA1 6-54