Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS, Функциональное описание

Страница: 478 / 490

17-8
Index ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
NOP 6-45, 7-1
not homed 12-57
Number of EcoX Slaves 12-28
O
Offset dimension too small 12-56
Open Feed Roll I 9-19
Operating Modes 8-1
OR 7-1
OR( 7-1
ORN 7-1
ORN( 7-1
Output Automatic Mode 10-6
Output Fault 10-6
Output Manual Mode 10-6
Output Ready 10-6
Output Warning 10-6
Outputs 10-7
Outputs overloaded 12-63
Overcurrent
short in power stage 12-20
Overtemperature in the EMD Module 12-14
Overvoltage in power stage 12-30
P
P2 12-50
P3 12-50
P4 12-50
PA 12-49
Parallel Interface DKC21.3 Programmable Inputs/Outputs 10-7
Parameter and automatic input simultaneously 12-51
Parameter calculation error 12-32
Parameter default value erroneous 12-42
Parameter error 12-58
Parameter input 10-3
Parameter limit error 12-32
Parameter Mode active
Output 9-21
Parameters not copyable 12-41
PBK 6-45
Peak current
Saving in the motor feedback memory 5-1
Per mil value in ACC command > 999 12-52
Pertinent parameters for encoder emulation 8-54
Pertinent parameters for homing 8-4
Pertinent Parameters for Measuring Wheel Mode 8-2
Pertinent Parameters for the motor holding brake 5-3
PFA 6-46
PFI 6-46
Phase 2 12-50
Phase 3 12-50
Phase 4 12-50
PL 12-50
PL Load parameter default values 12-4
Placement of the Home Switch 8-15
Plain Text Diagnostic Message 4-10
PLS 8-66
PLS speed > N109 12-61
POA 6-48
POI 6-49
Position control loop monitoring 8-48
Position data scaling error 12-34
Position Limit - 10-5
Position Limit + 10-5
Position Loop
Critical Position Loop Gain 8-48
Setting the Acceleration Feed Forward 8-50
Setting the position loop 8-47