4-18
Chapter 4. Functions
z
G.SOAK clear
In the pattern operation mode, the G.SOAK wait state can be canceled individually
for each control loop.
(1) Press the
[
]
(mode) button on the 1-loop monitor screen.
> The mode selection screen appears.
(2) Press the
[PATTERN]
button in the upper left corner of the screen.
> The mode selection screen for pattern operation appears.
(3) Press the
[CLEAR]
button to the right of G.SOAK CLEAR.
> The G.SOAK CLEAR execution confirmation screen appears.
(4) Press the
[CLEAR]
button.
> The G.SOAK wait period is canceled.
Handling Precautions
•
G.SOAK CLEAR can be used only in the G.SOAK wait state.
•
In the G.SOAK wait state, the SEG (segment) number display on the monitor
screen blinks.
z
AT (auto-tuning) stop/start
AT stop/start can be switched for each control loop independently.
z
z
AT stop
→
AT start
(1) Press the
[
]
(mode) button on the 1-loop monitor screen.
> The mode selection screen appears.
(2) Press the
[START]
button on the right side of AUTO TUNING.
> The confirmation screen for changing the mode to AT start appears.
(3) Press the
[START]
button.
> The AT starts.
z
z
AT start
→
AT stop
(1) Press the
[
]
(mode) button on the 1-loop monitor screen.
> The mode selection screen appears.
(2) Press the
[STOP]
button in the right side of AUTO TUNING.
> The confirmation screen for changing the mode to AT stop appears.
(3) Press the
[STOP]
button to stop AT.
Handling Precautions
•
AT can be started by either the master side or the slave side of the internal
cascade control. Master and slave cannot both start AT.
•
When AT is active in the pattern operation mode, the progress of pattern
operation is stopped even in the RUN mode. When AT stops or ends, the
controller returns to a state in which it can progress according to the RUN,
HOLD, END, or READY mode.
