
Installing Additional Controllers
74
Controller B1 v3.0 – 11 Installation in OS/2
:PROTOCOL = \x00
[ISDN-Controller-01]
IO Address = 250
Interrupt = 10
Base Module = b1tr6.t4
:PROTOCOL = \x06
Then switch off the computer and physically install the sec-
ond ISDN-Controller into the system. Make sure that the
jumper setting on the ISDN-Controller corresponds to the I/O
address entered in the file.
Also note the following:
l
When an AVM ISDN-Controller for a different type of bus
is added, the paragraphs of the ISDNLOAD.CFG file list-
ed above also must include the line
Type=XX
to spec-
ify the bus type.
l
If a PC controller is already installed and an ISA control-
ler is to be added, in addition to the I/O address and
the interrupt, the following value must be specified:
Type=B1at
.
l
If a PCI controller is to be added, and an ISA controller is
already installed, the corresponding entry is:
Type=B1pci
. For a PCI controller, it is not necessary to
enter the I/O address and interrupt. Also note the infor-
mation in the manual for the PCI controller.
The “B1 Load” program loads all installed controllers.
HB_B1V30.book Seite 74 Mittwoch, 7. Februar 2001 3:19 15