
Installing the Driver Software
ISDN-Controller B1 v3.0 – 4 Installation in Windows NT
23
5.
Click “Next”.
6.
The next window contains a list of the installed control-
lers. If no AVM ISDN-Controller is installed, the “New”
entry (add an ISDN-Controller) is already active.
Select the type of Controller to be installed and click
“Next”.
7.
In the next window, enter the folder in which the driver
software is to be installed.
8.
Enter the interrupt for the ISDN-Controller.
In the next dialog, select the I/O address for communi-
cation with the ISDN-Controller in the system. Click the
address that corresponds to the position of the jumper
on the ISDN-Controller card (see the section “Setting
the I/O Address” on page 14).
Confirm with “Next”.
9.
Enter in the next window which D-channel protocol is
used on your ISDN line.
Activate the desired option and then click “Next”. The
installation program now copies all files to the specified
folder.
10. As a final step, a window appears with the settings of
the ISDN-Controller B1 v3.0. Confirm by clicking “Next”.
This concludes the driver software installation in Windows
NT. Now the ISDN-Controller can be put into operation.
A new program group called “AVM” is created in the Program
Manager/Start menu. This program group contains the files
“AVM Internet Home Page”, “B1 Unload”, “B1 Load”, “B1
Readme”, “B1 Setup” and “B1 Test”.
If the I/O address and interrupt of the ISDN-Controller must
be changed after installation, for instance, because new
hardware devices were installed, change the position of the
jumper on the ISDN-Controller first. Then open the program
“B1 Setup” and enter the new values there.
HB_B1V30.book Seite 23 Mittwoch, 7. Februar 2001 3:19 15