
Configuring the ISDN-Controller B1 v3.0
ISDN-Controller B1 v3.0 – 5 Installation in Windows Millennium
29
It is advisable to accept the I/O address value displayed
here and, if necessary, to change the jumper position
on the ISDN-Controller accordingly. If you would prefer
to use another I/O address, open the Device Manager
(“Settings / Control Panel / System”) before restarting
Windows and enter the desired values there.
Now the driver software is copied to your computer. A
message appears announcing that the software for the
new hardware device has been installed. Click “Finish”.
10. A message in the next window announces that the com-
puter must be shut down. Remove the CD from the CD-
ROM drive and click “Yes”. The computer must be shut
down before the ISDN-Controller hardware is physically
installed so that all settings made can be activated.
11.
Turn off the computer and any other connected devices
and pull the power plug.
5.2 Configuring the ISDN-Controller
B1 v3.0
In the second step of installation, change the jumper posi-
tion on the AVM ISDN-Controller B1 v3.0 if necessary. Use the
value suggested by the Add New Hardware Wizard. Upon de-
livery, the jumper is set to the I/O address 150 (see the sec-
tion “Setting the I/O Address” on page 14).
Once the ISDN-Controller has been installed in Windows Me
and the jumper has been set, the ISDN-Controller B1 v3.0 can
be physically installed in the computer.
5.3 Physically Installing the ISDN-
Controller B1 v3.0
For the physical installation of the AVM ISDN-Controller
B1 v3.0 and the connection of the cables, follow the steps
described in the section “Installing the Hardware” on
page 14.
HB_B1V30.book Seite 29 Mittwoch, 7. Februar 2001 3:19 15