
Installation in Windows NT
22
ISDN-Controller B1 v3.0 – 4 Installation in Windows NT
4 Installation in Windows NT
For use in Microsoft Windows NT, specially developed drivers
are included with delivery. The CAPI 2.0 supplied with the
controller supports both 16-bit and 32-bit applications. Ap-
plications in DOS windows are not supported. For more infor-
mation about CAPI, see the section “The Applications Inter-
face CAPI 2.0” on page 78.
Before beginning with the software installation, check that
the ISDN-Controller has been installed in the computer prop-
erly. Make sure that an I/O address available in the computer
is set on the ISDN-Controller (see the section “Setting the I/O
Address” on page 14).
4.1 Installing the Driver Software
Note that administrator rights are required to perform the in-
stallation in Windows NT.
Proceed as follows to install the driver software in Windows
NT:
1.
Start Windows NT.
2.
Insert the “AVM ISDN-Controller B1 v3.0” CD in your CD-
ROM drive.
3.
Open the Windows NT Start menu and select the “Run”
command. Enter the path to the installation program in
the command line:
<CD-ROM DRIVE>:\CARDWARE\B1_v30\
WINDOWS.NT\ENGLISH\SETUP.EXE
Confirm by clicking “OK”.
4.
The welcome screen of the installation program ap-
pears. For more information about the ISDN-Controller
and the installation process, click “Read AVM Readme”
in this window.
Use the “F1” key at any time to view a help text about
the current installation step.
HB_B1V30.book Seite 22 Mittwoch, 7. Februar 2001 3:19 15