
Configuring the ISDN-Controller B1 v3.0
ISDN-Controller B1 v3.0 – 6 Installation in Windows 98
37
10. A message in the next window announces that the com-
puter must be shut down. Remove the CD from the CD-
ROM drive and click “Yes”. The computer must be shut
down before the ISDN-Controller hardware is physically
installed so that all settings made can be activated.
11.
Turn off the computer and any other connected devices
and pull the power plug.
6.2 Configuring the ISDN-Controller
B1 v3.0
In the second step of installation, change the jumper posi-
tion on the AVM ISDN-Controller B1 v3.0 if necessary. Use the
value suggested by the Add New Hardware Wizard. Upon de-
livery, the jumper is set to the I/O address 150 (see the sec-
tion “Setting the I/O Address” on page 14).
Once the ISDN-Controller has been installed in Windows Me
and the jumper has been set, the ISDN-Controller B1 v3.0 can
be physically installed in the computer.
6.3 Physically Installing the ISDN-
Controller B1 v3.0
For the physical installation of the AVM ISDN-Controller
B1 v3.0 and the connection of the cables, follow the steps
described in the section “Installing the Hardware” on
page 14.
6.4 Installing the Driver Software
After physically installing the ISDN-Controller B1 v3.0, the
next step is to install the driver software. Proceed as follows:
1.
Turn your computer back on. The welcome screen of the
installation program appears. To obtain more informa-
tion about the ISDN-Controller and the installation pro-
cess, click the “Read AVM Readme” button.
HB_B1V30.book Seite 37 Mittwoch, 7. Februar 2001 3:19 15