
Installing Additional Controllers
20
ISDN-Controller B1 v3.0 – 3 Installation in Windows 2000
4.
Click with the right mouse button on the entry “AVM
ISDN-Controller B1”.
5.
Select “Properties” and activate the “ISDN” settings
page.
On this page, select the D-channel protocol.
Click the “Configure” button to specify the multiple sub-
scriber numbers for the NDIS WAN CAPI Driver.
6.
Go to the “Resources” settings page. Click the “Change
settings...” button.
Here values for the I/O address and the interrupt can be
changed.
3.3 Installing Additional Controllers
Up to four active AVM ISDN-Controller can be installed in
your computer at any given time. It is also possible to com-
bine active AVM ISDN-Controllers for the ISA, PCI and USB
buses in one computer.
To install an additional ISDN-Controller for the PCI bus, sim-
ply install it in an appropriate slot according to the instruc-
tions in the chapter “Installing the Hardware” on page 14.
Make the entries described in the section “Installing the
Driver Software” on page 17. That’s all!
To add a PCI or USB controller, perform the installation of the
ISDN-Controller as described it the corresponding manual.
The driver software of all controllers installed is loaded auto-
matically when Windows 2000 is started.
3.4 Removing the ISDN-Controller B1 v3.0
To remove the AVM ISDN-Controller B1 v3.0 in Windows
2000, proceed as follows:
1.
Open the Windows 2000 Control Panel using “Start /
Settings” and double-click the “Add/Remove Hard-
ware” icon.
HB_B1V30.book Seite 20 Mittwoch, 7. Februar 2001 3:19 15