
Changing the Settings
ISDN-Controller B1 v3.0 – 3 Installation in Windows 2000
19
he MSNs entered here are valid for both incoming and
outgoing calls. The first MSN entry is valid for the first B
channel; the second for the second B channel. A maxi-
mum of two B channels are supported by the NDIS WAN
CAPI Driver. When a B channel is busy, the first MSN
(default MSN) will be signalled as the outgoing MSN.
Tip: simply enter the same MSN for both B channels to
follow all costs accrued on this number.
13.
Then click “Next”.
14. In conclusion, a window appears in which the settings
for the ISDN-Controller B1 v3.0 are displayed. Click “Fin-
ish”.
This concludes the installation of the driver software in Win-
dows 2000. You may start operation of the ISDN-Controller
immediately after installation, CAPI 2.0 and the AVM NDIS
WAN CAPI Driver are available. For detailed information
about the AVM NDIS WAN CAPI Driver and the two other AVM
system drivers, see the section “The AVM System Drivers” on
page 81.
3.2 Changing the Settings
After installation is concluded, you have the opportunity to
change the following settings:
l
the D-channel protocol
l
the multiple subscriber numbers (MSNs)
l
and the resources (I/O address and interrupt)
To make changes, proceed as follows:
1.
Open the Windows 2000 Control Panel by clicking
through “Start / Settings”, and then double-click “Sys-
tem”.
2.
Open the Device Manager on the “Hardware” settings
page.
3.
Click the “+” before the entry “Network adapters”.
HB_B1V30.book Seite 19 Mittwoch, 7. Februar 2001 3:19 15