
SYSTEM.INI
ISDN-Controller B1 v3.0 – 8 Installation in Windows 3.x
55
l
For a PCI controller, it is not necessary to enter the I/O
address and interrupt. Also note the information in the
manual for the PCI controller.
SYSTEM.INI
The same changes must be made in the SYSTEM.INI file as
well. The entry in SYSTEM.INI may look something like this:
[AVM ISDN-Controller B1]
Interrupt=5
IO Address=150
Type=B1at
The values for the new controller are simply added below
(with the specification of the controller number after the pa-
rameter):
Interrupt2=10
IO Address2=250
Type2=B1at
Use the “B1 Load” command to load all ISDN-Controllers in-
stalled.
8.6 Removing the ISDN-Controller B1 v3.0
To remove the AVM ISDN-Controller B1 v3.0 in Windows 3.x,
proceed as follows:
1.
Start the installation program from the “AVM ISDN-Con-
troller B1 v3.0” driver CD.
2.
The program reports that an installed controller was
found. Click “Next”.
3.
In next dialog, click “Uninstall” and once again “Next”.
Follow the instructions on the screen.
This concludes the removal of the AVM ISDN-Controller
B1 v3.0.
HB_B1V30.book Seite 55 Mittwoch, 7. Februar 2001 3:19 15