
Starting ISDN-Controller B1 v3.0 Operation with Stand-Alone CAPI
66
ISDN-Controller B1 v3.0 – 10 Installation in Novell NetWare
5.
Leave the configuration by pressing “Esc”. Select “Yes”
to confirm that you want to save the new settings.
The ISDN-Controller B1 v3.0 settings can be changed at any
time using this method.
10.3 Starting ISDN-Controller B1 v3.0
Operation with Stand-Alone CAPI
The ISDN-Controller must be loaded manually each time the
system is started.
Loading the ISDN-Controller
Enter the following command at the system console to load
the controller:
load capi20
A message appears reporting that the ISDN-Controller has
been loaded and the CAPI interface is available.
Unloading the ISDN-Controller
To unload the ISDN-Controller B1 v3.0, enter:
load capi20 -d
at the system console. The system displays a message con-
firming the action.
10.4 Installing Additional Controllers with
Stand-Alone CAPI
To install additional ISDN-Controllers, enter:
load b1setup
at the system console. In the list of available ISDN-Control-
lers, press “Ins”. Each time this operation is performed, an-
other ISDN-Controller is displayed, complete with an avail-
able I/O address and interrupt.
Next, follow the instructions in the section “ISDN-Controller
B1 v3.0 Configuration with Stand-Alone CAPI” on page 65.
HB_B1V30.book Seite 66 Mittwoch, 7. Februar 2001 3:19 15