
Installing Additional Controllers
ISDN-Controller B1 v3.0 – 9 Installation in MS-DOS
61
–
Base module (specifies the T4 file): “b1.t4” stands
for the D-channel protocol DSS1, “b1tr6.t4” for 1TR6,
and ”b1usa.t4” for NI1 and 5ESS
–
:PROTOCOL (specifies the D-channel protocol):
“\x00” stands for DSS1, “\x06” for 1TR6, “\x03” for
NI1, and “\x05” for 5ESS
Example:
[ISDN-Controller-00]
IO Address = 150
Interrupt = 5
Base Module = b1.t4
:PROTOCOL = \x00
[ISDN-Controller-01]
IO Address = 250
Interrupt = 10
Base Module = b1tr6.t4
:PROTOCOL = \x06
Also note the following:
l
When an AVM ISDN-Controller for a different type of bus
is added, the paragraphs of the ISDNLOAD.CFG file list-
ed above also must include the line
Type=XX
to spec-
ify the bus type.
l
If a PC controller is already installed and an ISA control-
ler is to be added, in addition to the I/O address and
the interrupt, the following value must be specified:
Type=B1at
.
l
If a PCI controller is to be added, and an ISA controller is
already installed, the corresponding entry is:
Type=B1pci
. For a PCI controller, it is not necessary to
enter the I/O address and interrupt. Also note the infor-
mation in the manual for the PCI controller.
HB_B1V30.book Seite 61 Mittwoch, 7. Februar 2001 3:19 15