
Installation in MS-DOS
56
ISDN-Controller B1 v3.0 – 9 Installation in MS-DOS
9 Installation in MS-DOS
For the use of the AVM ISDN-Controller B1 v3.0 in MS-DOS,
special drivers are included with delivery. Once installed, the
driver software makes the programming interface CAPI 2.0
available to the entire system. For more information about
CAPI, see the section “The Applications Interface CAPI 2.0”
on page 78.
9.1 Installing the Driver Software
Before beginning with the software installation, check that
the ISDN-Controller has been installed in the computer prop-
erly. Make sure that an I/O address available in the computer
is set on the ISDN-Controller (see the section “Setting the I/O
Address” on page 14).
Proceed as follows to install the driver software for the ISDN-
Controller B1 v3.0:
1.
Insert the “AVM ISDN-Controller B1 v3.0” CD in your CD-
ROM drive.
2.
Change to the letter of the CD-ROM drive. Then use the
customary DOS commands to switch to the following di-
rectory:
CARDWARE\B1_V30\DOS\ENGLISH
3.
Start the installation by entering the following com-
mand at the DOS prompt:
install
If the installation files are located in another directory,
enter the appropriate path.
4.
The welcome screen of the installation program ap-
pears. Installation can be aborted at any time by press-
ing “Ctrl+x”. To begin installation, press “Return”.
5.
An overview of the available drives appears. Select the
drive to which the driver software of the ISDN-Controller
is to be installed.
HB_B1V30.book Seite 56 Mittwoch, 7. Februar 2001 3:19 15