
Starting Operation of the ISDN-Controller B1 v3.0
ISDN-Controller B1 v3.0 – 9 Installation in MS-DOS
59
If the I/O address and interrupt of the ISDN-Controller must
be changed after installation, for instance, because new
hardware devices were installed, change the position of the
jumper on the ISDN-Controller first. Then open the program
“B1 Setup” and enter the new values there.
9.3 Starting Operation of the ISDN-
Controller B1 v3.0
Loading the ISDN-Controller
Now operation of the ISDN-Controller may begin. Switch to
the directory of the driver software of the ISDN-Controller,
e.g. IDRIVER, and enter the following command at the DOS
prompt:
ibase
This command initializes the ISDN-Controller and loads the
driver software. Once the controller has been loaded suc-
cessfully, the following message appears on the screen:
Message after loading in MS-DOS
Now you may begin working with CAPI applications. The AVM
ISDN-Controller B1 v3.0 driver for the support of the D-chan-
nel protocols and CAPI occupies about 18 KB in your PC’s
memory.
Unloading the ISDN-Controller
Enter the following command to unload the driver software:
ibase -
The program returns a message acknowledging that the driv-
er has been removed.
AVM Berlin
ISDN-Controller B1
COMMON-ISDN-API Version 2.0
E-DSS1 / Release xxxxxx
Serial No. xxxxxxx
Address xxx / IRQ x
Add. Service: Telefax G3, Fax Polling, DTMF, V.110, V.120, GSM,
CAPI 1.1
HB_B1V30.book Seite 59 Mittwoch, 7. Februar 2001 3:19 15