
ISDN-Controller B1 v3.0 Configuration with Stand-Alone CAPI
ISDN-Controller B1 v3.0 – 10 Installation in Novell NetWare
65
At the conclusion of installation, the README file for the
AVM ISDN-Controller B1 v3.0 is displayed on the screen.
9.
Press “Esc” to end the display.
10. Press “Esc” as often as necessary to close all sub-
menus and return to the “Configuration Options” menu.
11.
Select “Exit” to leave the installation program.
For operation and configuration with the Stand-Alone CAPI,
continue with the next two sections. To perform the installa-
tion with CAPI for the CAPI Manager, proceed as described in
the section “ISDN-Controller B1 v3.0 with CAPI for the CAPI
Manager” on page 67.
10.2 ISDN-Controller B1 v3.0 Configuration
with Stand-Alone CAPI
To configure the AVM ISDN-Controller B1 v3.0 with Stand-
Alone CAPI, proceed as follows:
1.
Enter the following command at the system console:
load b1setup
A list of available ISDN-Controllers with their I/O ad-
dresses, interrupts and D-channel protocols appears.
2.
Use the cursor keys to select the controller to be config-
ured from this list and then press “Return”.
3.
The configuration window for the AVM ISDN-Controller
B1 v3.0 appears. Here you can perform the settings for
the I/O address, interrupt, D-channel protocol, the
Point-to-Point protocol (Direct Dial-In) and automatic
data compression.
For more information about CAPI SoftCompression, see
the section “CAPI SoftCompression X75/V42bis” on
page 83.
4.
Move the selection bar to each entry and press “Re-
turn”. Select the desired setting from the list displayed
or enter the new value in the active input field.
HB_B1V30.book Seite 65 Mittwoch, 7. Februar 2001 3:19 15