ABB ACQ80, Руководство по прошивке

Страница: 351 / 390

Fieldbus control through the embedded fieldbus interface (EFB) 351
Control Word
 Control Word for the ABB Drives profile
The table below shows the contents of the fieldbus Control Word for the ABB
Drives control profile. The embedded fieldbus interface converts this word to
the form in which it is used in the drive. The upper case boldface text refers to
the states shown in
State transition diagram for the ABB Drives profile
on page
358
.
Bit Name Value STATE/Description
0 OFF1_
CONTROL 1 Proceed to READY TO OPERATE.
0 Stop along currently active deceleration ramp.
Proceed to
OFF1 ACTIVE ; proceed to READY TO
SWITCH ON unless other interlocks (OFF2, OFF3) are
active.
1 OFF2_
CONTROL
1 Continue operation (OFF2 inactive).
0 Emergency OFF, coast to stop.
Proceed to OFF2 ACTIVE , proceed to SWITCH-ON
INHIBITED .
2 OFF3_
CONTROL 1 Continue operation (OFF3 inactive).
0 Emergency stop, stop within time defined by drive
parameter. Proceed to
OFF3 ACTIVE ; proceed to
SWITCH-ON INHIBITED .
Warning: Ensure that the motor and driven machine
can be stopped using this stop mode.
3 INHIBIT_
OPERATION
1 Proceed to OPERATION D .
Note: Run enable signal must be active; see the drive
documentation. If the drive is set to receive the Run
enable signal from the fieldbus, this bit activates the
signal.
0 Inhibit operation. Proceed to OPERATION INHIBITED .
4 RAMP_OUT_
ZERO 1 Normal operation. Proceed to RAMP FUNCTION
GENERATOR: OUTPUT D .
0 Force Ramp Function Generator output to zero. Drive
ramps to stop (current and DC voltage limits in force).
5 RAMP_HOLD 1 ramp function. Proceed to RAMP FUNCTION
GENERATOR: ACCELERATOR D .
0 Halt ramping (Ramp Function Generator output held).
6 RAMP_IN_
ZERO
1 Normal operation. Proceed to OPERATING .
Note: This bit is effective only if the fieldbus interface
is set as the source for this signal by drive
parameters.
0 Force Ramp Function Generator input to zero.