ABB ACQ80, Руководство по прошивке

Страница: 28 / 390

28 Startup, control with I/O and ID run
Select ID run (shown only when the drive is in
vector control mode) and press
( Select ) (or ).
Select the type of ID run you want to do and
press ( Select ) (or ).
Warning message Identification run is
shown at the top for a few seconds.
Control panel LED starts blinking green to
indicate an active warning.
Check the motor limits shown on the control
panel. If you need other limits during the ID
run you can enter them here. The originals
limits will be restored after the ID run.
Press
( Next ).
Press the start key ( ) to start the ID run.
In general, ABB recommends not to press
any control panel keys during the ID run.
However, you can stop the ID run at any time
by pressing the stop key (
).
During the ID run a progress view is shown.
After the ID run is completed, text
ID run
done is shown. The LED stops blinking.
If the ID run fails, fault
FF61 ID run
is shown.
See chapter
Fault tracing
on page
303
for
more information.