Setup
ORB Operating Manual – Issue 1.0
Page 69
WYSIWYG (
http://www.castlighting.com
)
WYSIWYG Requirements
•
A current (Release 21 or greater) installation of WYSIWYG
Perform
•
The Zero 88 consoles file (provided on the Cast website)
•
The Zero 88 WYSIWYG Driver (provided on the Zero 88 website,
or on the CD with the desk)
•
An Ethernet connection to your Zero 88 console
WYSIWYG Installation
•
First install WYSIWYG Release 22 or greater, following the
standard procedure (if you’re using Release 21, you’ll need the
Zero 88 Consoles CFB file)
•
Run the Zero 88 WYSIWYG Driver installation tool
•
Once the driver is installed, run the tool
•
Select the network interface you wish to connect WYSIWYG with
(the IP address is shown)
•
Choose OK
WYSIWYG Usage
•
Start WYSIWYG & load your show file
•
Patch your fixtures to Universes in WYSIWYG
•
In the LIVE tab, select LIVE, Device Manager
•
In Device Manager, select New and locate the
Zero 88 console you are connecting to
•
Select the console and click Properties, then enter the IP
address of the desk in the Address. Select each Port on the
desk and Bind these to a Universe on WYSIWYG.
Summary of Contents for ORB
Page 1: ...ORB OPERATING MANUAL...
