Advanced Programming
Page 118
ORB Operating Manual – Issue 1.0
Complete the record operation by pressing the ENTER key.
Wheel Editing Modes
The desk provides a number of wheel editing modes which are user
selectable and apply when editing several fixtures at the same time.
For each attribute there is an unshifted and a shifted wheel mode.
The unshifted wheel mode is applied when the control wheel is
moved. The shifted wheel mode is applied when the SHIFT key is
held down and the wheel is moved.
The current wheel edit mode for the currently selected attribute is
displayed on the LCD screen above the wheels. To change the
editing mode, hold down SETUP and press the relevant attribute.
Figure 84 - Set Colour Wheel Editing Mode
The different wheel editing modes are described below:
Absolute Mode
When several fixtures are selected and a fixture parameter is
adjusted using a control wheel, the adjusted parameter for all the
selected fixtures goes to the same absolute value. For example –
Select fixtures 1 – 5 and adjust a parameter:
Fixture
Parameter
Fixture 1
Fixture 2
Fixture 3
Fixture 4
Fixture 5
Original
Value
30 20 40 10 50
New
Value
15 15 15 15 15
Change
in
Value
-15 -5 -25 +5 -35
Relative Mode
When several fixtures are selected and a fixture parameter is
adjusted using a control wheel, that parameter on each of the
Summary of Contents for ORB
Page 1: ...ORB OPERATING MANUAL...
