Xerox WORKCENTRE 7428, System Administrator Manual, Page: 24 / 208

Administrative Tools
WorkCentre 7425/7428/7435
System Administrator Guide 24
5. To exit the screen, without making any changes, press the Cancel button.
Internet Services Port Number
1. Press Internet Services Port Number in the Internet Services (HTTP) menu.
2. Press Change Settings .
3. On the Port Number screen, use the keypad to enter the port number (default of 80).
4. Press
Save .
5. Press Cancel to exit without making changes.
6. To exit the Internet Services Selection Menu touch Close in the upper right corner of the touch
screen.
7. To exit the Port Settings menu, returning to the printer's Tools screen, touch
Close
again.
Proxy Server Settings
To use the Web Service button on the printer (if available), which enables the printer to access HTTP
file servers on the Internet, you need to enter your Proxy Server information as described here.
1. Open your Web browser and enter the IP address of the printer in the address field. Press
Enter to
open CentreWare Internet Services.
2. Click the
Properties
tab.
3. Enter the system administrator User Name and Password (default
admin
,
1111
) if prompted.
4. Click the
Connectivity
folder, then the
Protocols
folder.
5. Select
Proxy Server Settings
folder.
6. Place a check mark in the
Use Proxy Server
check box.
7. From the
Proxy Setup
drop down menu, select either
Same Proxy for All Protocols
, or
Different
Proxy for each Protocol , depending upon your Proxy Server setup.
8. In the Addresses to Bypass Proxy Server box, enter up to 1024 characters of IP addresses, fully
qualified host names, or wildcard host names (such as *.eng), separated by semicolons. Functioning
like the local address exception list in a typical Web browser, these addresses will be permitted to
bypass the Proxy Server.
9. For the
HTTP or HTTPS Server Name
s, provide a name of up to 255 characters in length for one or
both of these Proxy Servers. A fully qualified domain name or IP address can be used.
Note: Make sure that DNS is enabled See TCP/IP Protocol Configuration on page 43.
10. Leave the Port Number set to 8080 (the IANA recognized proxy port) unless you are using a
different port number. If you are using a different port number, enter it in the available box.
11. Check the
Authentication
box if client authentication is required for the Proxy Server.
12. Enter the
Login Name
for access to the proxy server. Up to 32 characters can be entered.
13. Enter the
Password
for access to the proxy server. Up to 32 characters can be entered.
14. Click
Apply
.
15. Enter the System Administrator user ID and password when prompted and click
OK
.